mp⼀mc模式有和区别？

Microprocessor/Microcomputer Mode Select. Switchesbetween microprocessor and microcomputer mode. Whenhigh, Zone 7 is enabled on the external interface. When low,Zone 7 is disabled from the external interface, and on-chipboot ROM may be accessed instead. This signal is latchedinto the XINTCNF2 register on a reset and the user can modifythis bit in software. The state of the XMP/MC pin is ignoredafter reset.0：bootrom区在片内（出厂已有）1：bootrom在ZONE7，需要自己做。

俺就知道一个，烧写就接地，仿真就断开，呵呵

呵呵……这么说程序烧到FLASH里就不能仿真啦？！！！